• Necessary equipment:
– Remote control with module, bound to the drone (trainer)
– Remote control without module (student)
– Mini jack 3.5/mini jack 3.5 cable up to 20 meters.
• Setting up remote controls.
Trainer:
– Go to the model settings – MOD button
– SETUP page (2/12)
– Trainer line
– Mode – Master/Jack
– SPECIAL FUNCTIONS page (10/12), settings according to the image.
Assign the toggle switch to turn on the trainer mode, and in what position the trainer mode is turned on.
(In the example, this is the F toggle switch)
Student:
– Go to the model settings – MOD button
– SETUP page (2/12)
– Trainer line
– Mode – Slave/Jack (it is the default. But it is better to check)
• Connect the remotes using a cable.
• When the trainer mode is turned off, control is carried out through the student’s remote.
The sticks on the trainer’s remote are inactive.
When the trainer mode is turned off, control goes to the trainer’s remote, the student’s remote is turned off.
Соединяем пульты с помощью кабеля.
• При выключенном режиме тренера, управление осуществляется через пульт ученика.
Стики на пульте тренера неактивны.
При отключении режима тренера, управление переходит на пульт тренера, ученический пульт отключается.
