“GPS faker” now for DJI Matrice 300
Now our easy-to-install (no soldering required, all necessary tools included, installs in 20 minutes) boards for substituting a GPS signal (“GPS-faker”) are available for the DJI Matrice 300
The board has the following features:
1. Two operating modes: “Set constant coordinates” / “GPS imitation” (work without GPS – the entire flight, the drone’s location coordinates are static, so the drone is not susceptible to GPS spoofing attacks (substitution of coordinates, i.e. “hijacking”) and “Drone displacement” (GPS is used, but with a shift from real coordinates; in this case, the drone may be subject to “hijacking”);
2. Take-off and flight without satellites or in conditions of their suppression (“fast take-off”);
3. Makes it possible to bypass the NFZ (No Fly Zone) restriction by shifting coordinates;
4. Makes it possible to enable FCC mode (increases the communication range with the drone) through a coordinate shift;
5. Avoids broadcasting the drone’s true coordinates via DRONE ID.
The board’s operating modes are controlled both using microswitches on the board itself and via Wi-Fi via any smartphone.
It is important to note that the board does NOT block broadcasting of the coordinates of the remote control/phone (that is, the operator) via DRONE ID!
The boards are already being distributed to service centers and repair centers, as well as directly to departments.
The message below contains instructions for installing the boards and operating them.
