The muskrat is ready))) – DJI AVATA

We make “reflashing” of Avatar with our own hands.
We increase the flight range, install protection against spoofing and add the ability to fly in NFZ.

We quickly put it together from what we had on hand (+ designed a housing for the low-range gearbox).
The solution works, although it may look “unaesthetic”.

They made it from what they had (list)
– Battery 2S, 7.4V, 3000 mAh, XT60
– USB type A (AF) connector removed from a non-working charger
– Voltage stabilizer L7805 5V
– XT60 male connector
– 3D printed case (layout.stl will be posted in СВОи_FPV_выЗOV)
– Battery strap from FPV
For aesthetics, we need a number of kits, we ordered them and are waiting.

What we call aesthetics: at a minimum, when the wires don’t stick out and it’s as compact as possible.
In fact: the pilots tie it with tape and it’s fine)))

But we will still formalize the aesthetics on Avata

DJI Fly app – flight application for controlling DJI drones (consumer versions), installed on:
– phone/tablet (use with DJI RC-N1 remote control)
– DJI RC remote control
– DJI RC Pro consumer version (mb510b
– DJI RC Pro enterprise version (mb510) and DJI RC Plus under COS control.

Supported Drones
– DJI Mini/Mini SE
– DJI Mini 2/Mini 2 SE
– DJI Air 2/Air 2S
– DJI Mini 3/Mini 3 Pro
– DJI Air 3/3S
– DJI Mavic 3/3 Classic/3 Cine/3 Pro
– DJI Mini 4 Pro
– DJI Neo
– DJI FPV
– DJI Avata/Avata 2

Important
1. If the drone has firmware 1001, you can use any version of DJI Fly , at the moment the newest is 1.15.0 , you can download it from the official DJI website or here.
2. If you use Drone ID disabling with BitFlip or CIAJeepDoors, you can only use the application version NOT higher than 1.5.0 , you can download it here .

📎 If the drone is controlled via the DJI Fly app, we recommend additionally installing Eye Light

We will design a new layout and post it.
In the end, we will show and tell.


#обучение_качественно
#сильная_Россия