1001,” for DJI Matrice 30, Mavic 3 Pro and Mavic 3E

“1001,” for DJI Matrice 30, Mavic 3 Pro and Mavic 3E

We’ve expanded DJI’s “1001” firmware support to the DJI drone lineup by porting our firmware to the Matrice 30 (including the Matrice 30T), Mavic 3 Pro, and Mavic 3E.

Now special laptops for firmware will be able to install “1001,” on Mavic 3, Mavic 3T/E, Mavic 3 Classic, Mavic 3 Pro, as well as on Matrice 30(T) .

In less than two months of the existence of “1001,” more than 6,500 drones have already been installed on it! The list of points in the DPR, LPR and other regions of Russia has also grown where you can flash the Mavic 3 and Matrice 30(T) line – contact them to flash the firmware for your drones. And once again we remind you that the firmware is carried out exclusively free of charge (including the imposition of additional paid services) and only for use within the framework of the SVO.

In the update, we added the ability to “roll back” to the “factory” firmware of Mavic 3 drones (for now only on this model) with “1001,” to perform repairs, in particular gimbal calibration.

We also updated the “1001” firmware itself , it has new features:
• the function of recording and storing flights has been removed – flight trajectories cannot be extracted from the drone (for now, with the exception of 3 Pro and Matrice 30(T));
• disabled OpenDroneID – a function that sends data about the drone via Wi-Fi;
• added “fcc_on,” and “fcc_off,” commands to force enable and disable FCC+ 5.8 GHz (disabling is necessary for drones that have amplifiers installed to operate only at 2.4 GHz);
• the warning about being in the NFZ has been removed (previously, despite the lifting of the restriction on drone flights in such zones, the warning with a counter remained on the screen);
• now the command “lost_500,” is entered in the firmware drone by default.

The Matrice 30(T) has the same features as the Mavic 3T/E:
• turning on the bottom light by double pressing the button;
• territorial restrictions have been removed for the CN version of drones (drones are only for the Chinese market – they take off only in China) – now the drone takes off everywhere, including in Russia.

The only difference between “1001,” for the M30(T) is that there is no “hand fit” 🙂